CEL-MAR ADA-13040MG Manual de usuario descargar pdf (Pagina 18)

5.3.2.1.3.2. UDP CLIENT & SERVER CONFIGURATION IN CASE OF SLAVE DEVICE

Set operating parameters of UDP server for SLAVE device connected via serial port to ADA-13040MG, eg like on picture below. Set

an access to UDP server on e.g. 2101 port. Then select Automatically send serial data in section UDP Client Settings, this

automatically send received data by the use UDP client service to the MASTER device connected to LAN / WAN through e.g.

ADA-13020, ADA-13028L, ADA-13040MG, ADA-13110, ADA14040, ADA-14040.

On lists Send data to the following network services are addresses of network devices and ports to which will be send data. In

field:

– Description - enter e.g. location of the converter and MASTER device,

– Send To - enter IP address of e.g. converter, connected to MASTER device,

– UDP Port - enter the number of port on which is working UDP Server of converter connected to MASTER device and press

[Add]

In the section Send data under any of the following conditions is recommended to set parameters like on picture bellow.

For saving the configuration of UDP client and server for SLAVE device, press [Apply].

Fig. 20. Example configuration of the UDP server&client on converter connected to SLAVE device

ATTENTION !

Default port of serial port service is 2101.

If on the local network is conflict with other network service using the same port, in the converter's port configuration

change number of port into another for the server and client service.

ADA-13040MG

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Sin comentarios

CEL-MAR ADA-13040MG Manual de usuario Pagina 18